Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
hi, when I try to put the material into the object, the image comes out of the margin as zoomed in, or is simply stretched out. even if the created object is the same size as the image, i.e. 14.99 cm wide and 7,495 cm long
hi, when I try to put the material into the object, the image comes out of the margin as zoomed in, or is simply stretched out. even if the created object is the same size as the image, i.e. 14.99 cm wide and 7,495 cm long
Check which type of material mapping is being used. If planar make sure it is oriented parallel to the plane that you want the image on.
You might find that interactively adjusting the map size gizmo as needed is more effective than setting numerical values. The control of material mapping in AutoCAD leaves a lot to be desired.
Check which type of material mapping is being used. If planar make sure it is oriented parallel to the plane that you want the image on.
You might find that interactively adjusting the map size gizmo as needed is more effective than setting numerical values. The control of material mapping in AutoCAD leaves a lot to be desired.
