Does anyone know how to set the NC for mark the principal profile for assembly?
Mark all the contour; mark only the reference points and mark the name? (Check image P1 and P2).
Thanks a lot!
Solved! Go to Solution.
Solved by haedicu. Go to Solution.
Hi,
go in Management Tool to defaults and filter for "scrib" - you will find a few defaults, where you can define complete / end lines, distance, set contour marking on/off.
You have to set the NC based on main part numbers too in NC settings.
If you create the nc-files afterwards - they should contain the contour marking information. You can check this easily in the nc-dxf files (preview under document management).
best regards
Udo
Can't find what you're looking for? Ask the community or share your knowledge.