Contour Mark in NC for Assembly

[Anonymous]

Does anyone know how to set the NC for mark the principal profile for assembly? 

Mark all the contour; mark only the reference points and mark the name? (Check image P1 and P2).

Thanks a lot!

[haedicu · Accepted solution]

Hi,

go in Management Tool to defaults and filter for "scrib" - you will find a few defaults, where you can define complete / end lines, distance, set contour marking on/off.

You have to set the NC based on main part numbers too in NC settings.

If you create the nc-files afterwards - they should contain the contour marking information. You can check this easily in the nc-dxf files (preview under document management).

best regards

Udo

[Anonymous]

It worked! Thank you a lot!