polyline fillet or stretch creates zero length line segment v2013

[Anonymous]

When I stretch or fillet this polyline it creates the 2 zero length lines (when exploded) which my laser picks up and skips over. Is there a way to stop or at least predict when this will happen? It is unrealistic to have to explode and check every polyline you fillet or stretch. Please help...

[Patchy]

You could ask the Customization Group see if an autolisp can be made to eliminate a zero length in a polyline.

If they are individual lines, remove a zero length line routine is all over the web.

[Sofia.Xanthopoulou]

Hi @Anonymous,

this might be a matter on how this line has been created. Please use the methods described in this article.

Regards

-----------------------------
Please accept as solution if my post fully resolves your issue, or reply with additional details if the problem persists.

[Anonymous]

No the issue is just in polylines. What/where (link) is the Customization Group?

[Patchy]

They are in here:

http://forums.autodesk.com/t5/visual-lisp-autolisp-and-general/bd-p/130

[Sofia.Xanthopoulou]

I will move your post to the customization forum 

Regards

[hmsilva · Accepted solution]

Use the 'Overkill' command with the 'Optimize segments within polylines' option checked, to remove the zero length segments.

Hope this helps,
Henrique