LinkedIn
X (Twitter)
Facebook
Hello everyone
I want to create an automatic Mira ruler. can you help me with this? ( width: 6cm fix )
Height (cm) ? : 250
Direction (Front/Back): F
Specify point>
front
back
Thanks in advance for the help friend.
E Face staff ?
What is problem the level staff is a repeating pattern, bothe sides, based on the E face of 10mm solids not hard to make a block, array text & block. Edit text it would be a one off so it will take longer to write program than to do it.
PS a new one is $77.
Yes, you may be right. I thought of doing it as a dynamic block before I wrote a message...
However, if you want to add the Front/Back option, there must be two separate blocks. not very practical. so lisp code was my choice.
also if it happens with lisp code, I will add it to my program that I continue to develop in C #
yes, it seems a bit difficult... I think the friend who is available can help
Thank you.
Let me simplify the matter a little; It's just the front too...
You can have one block and use visiblity states to have it show the front or back.
altitude is important. should be designed by entering this value. For this reason, the block may not be suitable.
Thanks.
never-displayed
