how to clear (*pop-error-mode*) using

[MakCADD]

How can i clear this error message using VBA

which occurs while escaping from the express commands

(*pop-error-mode*) underflow.
Cannot invoke (command) from *error* without prior call to (*push-error-using-command*).
Converting (command) calls to (command-s) is recommended.

every time I have to restart the autocad to use the express commands again

[Ed__Jobe]

Are we to assume that you are using VBA SendCommand to call these lisp routines? Which Express commands are you having trouble with?

[MakCADD]

this is the error message from autocad, when I break the execution of an autocad express command

then you will get the same error message while using the express commands untill you restart autocad

I did it before with the help of someone

using lisp,  I forgot it,  I am not familiar with lisp

so i  thought it could be better to to use with sendcommand

instead of restarting autocad everytime

[Ed__Jobe]

You didn't say which ET commands you are having a problem with.

[MakCADD]

GATTE command  to edit attributes

[Ed__Jobe]

If I just run the command, I can't replicate your error. What steps are you using to get the error?

[MakCADD]

i cancelled the command using esc key without selecting any objects

then i revoke the command again ,  it shows the error

it shows the same error for other express commands

[Ed__Jobe]

I typed "GATTE" at the command line and hit ESC, but I can't replicate your error. Are you using this command in VBA? Is that why you are posting in the VBA forum and not the lisp forum? I've been using VBA and C# for a number of years, so my lisp is a little rusty.

[MakCADD]

@Ed__Jobe 

hello jobe,

thank you for your response.

yes, it is to be captured in lisp, I am not that much expert on lisp, so tried to find a solution through vba.

before i solved by entering the lisp code in command prompt using vba. (...utility.prompt) ,  i lost that code.

now  i could not revoke that error,  i dont know what happend.

next time ill copy all the command history  for your reference

again thanks for your time

[Ed__Jobe]

Then I would post this question in the LISP forum. I think some others have modified the ET commands. I think I did too, but can't remember what I did. I'm using 2021 now and it seems to be fixed.

[MakCADD]

Here is the command history for an express command for autonumbering

I hit the escape key,  instead of selecting the object. 

The result is this.

I used this command successfully right now.

now I have to restart autocad to eliminate this error

------------------------------------------------------------------------
Command:
TCOUNT

Select objects: Specify opposite corner: 10 found

Select objects:                                                                             

Sort selected objects by [X/Y/Select-order] <Y>:

Specify starting number and increment (Start,increment) <1,10>: 0,10

Placement of numbers in text [Overwrite/Prefix/Suffix/Find&replace..] < Overwrite>: *Cancel*     😀👾👾

Command:
Command: "INTERNAL error in FAIL\nmessage lost, reset to top"
Command: *Cancel*

Command: *Cancel*

Command:
TCOUNT

(*pop-error-mode*) underflow.
Cannot invoke (command) from *error* without prior call to (*push-error-using-command*).
Converting (command) calls to (command-s) is recommended.
Command:
TCOUNT

(*pop-error-mode*) underflow.
Cannot invoke (command) from *error* without prior call to (*push-error-using-command*).
Converting (command) calls to (command-s) is recommended.
Command: