Community
532 Views, 5 Replies
Hi,
As shown in picture 1 I have created this kind of column, with a variable cross section, larger at the top and smaller at the bottom, when looking for the results of the stresses inside the cross section, Robot will give an error, saying that parameters for the cross section are not given. For all the other standard cross sections of the structure I have no problem, and all the parameters for all the elements are stated correctly. Any suggestions on what the problem might be?
Thank you.
Looks good to me.
where exactly are you having problems?
Zip and attach the model ,if possible
Rafael Medeiros
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
I can see that, I cant see it from here. (the screenshot is in Italian, hope you can understand of what kind of result I am talking about)
Not working here too for any tapered sections. Maybe official autodesk support has an answer to this problem
@Rafal.Gaweda @Artur.Kosakowski
Rafael Medeiros
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Hi @Anonymous
@Rafacascudo is right. Tapered sections are not supported (recognized) by the stress analysis module.
Artur Kosakowski
Forums Links
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
