Member Properties not correct in Deflection checks

[sshasni]

Dear Members,

While calculating deflection checks, I am getting wrong Member properties as compared to those while calculating the AISC-360 Design checks. Please find attached both reports and advise how can i get correct member properties in deflection checks. I will be thankful.

[Krzysztof_Wasik]

HI @sshasni 

Share model with incorrectly regognized section properties for verification.

Save model as RTD without results and zip it before sharing.

[sshasni]

Thank you for your response. Please find attached model.

[Krzysztof_Wasik]

Hi @sshasni 

It seems like issue in American steel codes detailed analysis data, when only displacement (SLS ) is verified. I will try to check it with development tomorrow.

[Krzysztof_Wasik]

Hi @sshasni 

Hi I have confirmed it with development and registered as an issue for correction. As far as I could check incorrect information about properties (while SLS verification) does not have any influence on deflection verification (which is werified  correctly).

[sshasni]

Thank you very much for your kind support Krzysztof_Wasik. Looking forward for the final settlement of this issue.