Load Input Table - Filter Loads

[Anonymous]

Good afternoon,

I have a RSA model from a while back and I need to reinput loads.

I would like to edit the values for a number of these basic load cases, however there are lots! I cannot seem to invoke the 'filter' when using the right mouse just to edit values on basic loadcases.

is there a work around? 

Cheers

Lee

[Rafal.Gaweda]

..in Excel ?

Example:

[Anonymous]

Hi Rafal,

I was hoping to be able to filter out and edit individual loadcases in Robot, without other ones being visible: 

Can this be done in RSA 16? Can be problematic as once I start to edit, sometimes the cell reverts back to the original value!

Cheers

Lee

[Rafal.Gaweda · Accepted solution]

It is not possible to filter Loads table on Edit tab by loadcases

[Anonymous]

OK thanks Rafal!

I am still having intermittent issues updating the load values. I have tried opening up in repair mode, and when i replace value in table edit mode, the values reverts back to original?

[Rafal.Gaweda · Accepted solution]

Try the same but on Loads table opened on Geometry layout (not the one on Loads layout)