How can I apply linear load

[tomatomeski]

How can I apply linear load on steel truss with two different intensity like it's showed on my picture?

[Romanich]

Hi @tomatomeski,

It is not possible in one "load record". Just apply two linear loads.

[tomatomeski]

But the bigger load it is now applied along the length of the entire purlin, how can I apply it on specific part of the purlin?
Thanks

[Romanich · Accepted solution]

Hi @tomatomeski ,

I was wrong in my previous reply:

You can also use the same Trapezoidal Load dialog to add two 2 loads separately:

[tomatomeski]

thank you very much