Concrete Slab Design Results

[Anonymous]

I am working on the design of a concrete building, specifically a single concrete slab within the building. I run through the process of reinforcing design, redefine my strips, and assign bar size and spacing to each strip. Then when I save the project and re-open, I lose all the work that I just did. Is there a special save you need to do when you are in the process of reinforcement design?

[Artur.Kosakowski · Accepted solution]

Al the information should should saved within the file itself. Perhaps the situation is that you import panels from a model again rather than open them for accessing the already calculated reinforcement. This how it works:

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.