The table does not correctly count the bar length.

[aNGUloperry]

I was trying to create a steel schedule, and the table generated by Revit does not show the correct value for the rebar length. I searched and it seems to be a ‘K’ value that I cannot modify; it is a default value and for some reason, it is not counted in the schedule table. How can I correct this error?

[Tom_Kunsman]

Can you post a screen shot of your schedule? So hard to determine what is wrong without that or the model

[aNGUloperry]

Thanks for your answer, Tom! Sure, here it is.

The thing is, if you do the hand calculations (2*0.4 + 2*0.9 + 2*0.1 = 2.8m) and the schedule shows in all cases -6, -5, -8 cm, this affects the weight results obtained in the table and the real bar length

Reviewing the parameters, there is a "k" value, that I think is manipulating the Schedule result.

Thanks a lot for Ur help!

[aNGUloperry]

I apologize, is a "H" value, not "K".

[awes]

Please note the bending radius of the rebar.

[jay_colcombe]

as @awes