Hy,
I made a filter for one duct system to make a crosshatch pattern to the surface. (1. picture)
The pattern line weight is not thin like a normal pattern. (2. picture)
But the pattern line weight is set to 1 and the Line weights of the PEN 1 is set the minimum (3-4. picture)
If i change the PEN 4 line weight to the minimum weight the surface pattern will be good (5-6. picture)
How can i change the filter surface pattern line weight 4 to 1?
Thanks for helping!
Duct Surface Pattern filter line weight
take a look at this and see if it helps. its from the Arch forum, but....
Howard Munsell
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
