Automatic Transfer Switch (ATS) connectors - Prodesign 3D pluggin

[fernando.iliarte]

I am having some troubles in ProDesign 3D into Revit to make an ATS work.

If I am doing outside Revit, I don’t have any problems (see screenshot below)

If I try to make it work in Revit, Prodesign automatically change my Switchboard into a distribution board and is telling me that the families can have only one input connection.

Meanwhile Revit is connecting everything well

(IF is not the correct place to place the doubt, sorry in advance)                                                                                                                                                                                                                                            

Thank you so much

Regards,

[fernando.iliarte]

I am having some troubles in ProDesign 3D into Revit to make an ATS work.

If I am doing outside Revit, I don’t have any problems (see screenshot below)

If I try to make it work in Revit, Prodesign automatically change my Switchboard into a distribution board and is telling me that the families can have only one input connection.

Meanwhile Revit is connecting everything well

(IF is not the correct place to place the doubt, sorry in advance)                                                                                                                                                                                                                                            

Thank you so much

Regards,

[n_omatsola]

Any update on making this work?

[n_omatsola]

Any update on making this work?