How do I either prevent, or disconnect, two adjacent walls from locking themselves together? I have not used any locks anywhere, but when I want to move one of them, revit stubbornly insists on moving both. This has happened a few times, and I've put in some joints, but if this carries on my whole model will be filled with joints... I have to make sure I keep them separate until I think I've finished, and then move them into place - really not the easiest way to do things. In my latest case one wall is the wall below a ramp (which doglegs with a landing - another story, that, I had to put a 1mm gap between the two ramps to get revit to do it) and the other elements are the walls of a room next to the ramp. If I move the room into place and then try to adjust anything on it, it moves the ramp wall, too.
Thanks.
Solved! Go to Solution.
Solved by ToanDN. Go to Solution.
Can't find what you're looking for? Ask the community or share your knowledge.