Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I have a simple stacked wall and I need to make an opening through it. I have tried used int opening "wall" tool but it seems to offset the opening by 10mm and doesn't cut all the way. I have no way to move the opening over at all. Everything is on the existing phase. So far my work around is to use a structural door opening.
If I use the opening tool on a non-stacked wall, no problem. Door and windows also cut the stacked wall no problem.
I have a simple stacked wall and I need to make an opening through it. I have tried used int opening "wall" tool but it seems to offset the opening by 10mm and doesn't cut all the way. I have no way to move the opening over at all. Everything is on the existing phase. So far my work around is to use a structural door opening.
If I use the opening tool on a non-stacked wall, no problem. Door and windows also cut the stacked wall no problem.
