Wall folding

[Anonymous]

Hello, 

I want put the level of wall under the pavement. To lower the wall I use heigher offset. 

I ask if there is a specific command folding the wall between pavements?

Maybe these in attechment 2 (folding of the inserts or folding of extremes)?

Thank's

[MostafaElashmawy]

Firstly unlock all the layers , then you will be able to move the top handle of the wall to align it with the bottom of the pavement.

if you are using a normal wall (not compound) you can only use attach tool.

[Anonymous]

@MostafaElashmawy thank's for your answer. 

I want to keep two different levels of wall. The external allign to the top layer of pavement. 

The internal down the pavement as in attachment 1. 

Ask if there is a command that allow this without use offset command. Is not these in attachment 2?

Thank's

[Ilic.Andrej]

Set wall top to be aligned with the level and then use join geometry tool to clean up the join. Is that what you wanted?

[Anonymous]

Ask if there is a command or a type of property wall can allow to put the wall from the top level to the base lavel of the pavement without use offset ( -0.362 in this particular case).

[MostafaElashmawy]

Usually it's the attach tool.
but it will not work for your case because you need some layers in different level.

[ToanDN]

If you have some thing such as a floor at -0.362 elevation tgen you can attach the bottom of the wall to it.

[Ilic.Andrej · Accepted solution]

This is not answer to your initial question, but I think this is what you actually need: