View pattern as funciton of scale

[Anonymous]

Hello, 

If I put 0.1 on scale on finishes i don't view the pattern.

If I put 0.2 yes but not in the side farther.

When I render I view however the pattern?

Thank's

[RDAOU · Accepted solution]

You do not need to worry they are there you just don't see them because the scale of the Pattern is too small compared to the scale of the view...If a Model Pattern is too dense and crumbly with small line take quite some to regenerate. If you zoom in close and give it a few seconds you should see it.

Might also help a bit if you disable "Use Hardware Acceleration"; Otherwise, if nothing works you need to look for a better pattern 🙂 see screencast below for results

[Anonymous]

@RDAOU  which screencast?

Thank's a lot! :))

[RDAOU]

Not sure why it is not loading...I can see it on my end.

[Anonymous]

@RDAOU  but when I do render is visible, right?

Last question of the day.

Thank's !

[RDAOU]

Somewhat right because the pattern will not really matter:) when you render you will see the render Appearance and which ever image and bump you set over there...below is not yours but what I mean that's the tab where you set your render appearance

[Anonymous]

Later I'll try.

Thank's!