Community

Swept Blend edge showing in family

Swept Blend edge showing in family

AnnaK246
Contributor Contributor
600 Views
6 Replies
Message 1 of 7

Swept Blend edge showing in family

AnnaK246
Contributor
Contributor
‎03-20-2022 05:54 PM

I have created a dining chair, it has swept blend legs and it is successfully joined to the seat. Part of the top of the legs (a swept blend) is showing in plan. They finish well below the top of the seat. Changing the seat thickness or leg profile doesn't fix it. Even unjoining and lowering the top of the legs doesn't fix it. These dots/lines show up when printed to PDF as well. Any ideas to fix?dining chair.JPG

Dining Chair.rfa
0 Likes
Like
Report
601 Views
6 Replies
Replies (6)
Message 2 of 7

ennujozlagam
Mentor
Mentor
‎03-21-2022 01:10 AM

share you family so we can check?





Remember : without the difficult times in your LIFE, you wouldn't be who you are today. Be grateful for the good and the bad. ANGER doesn't solve anything. It builds nothing, but it can destroy everything...
Please mark this response as "Accept as Solution" if it answers your question. Kudos gladly accepted.
0 Likes
Like
Report
Message 3 of 7

AnnaK246
Contributor
Contributor
in reply to ennujozlagam
‎03-21-2022 01:34 AM

Oh yes here it is. Thank you for taking a look

Dining Chair.rfa
0 Likes
Like
Report
Message 4 of 7

ToanDN
Consultant
Consultant
in reply to AnnaK246
‎03-21-2022 10:06 AM

If all else fail, you could add a masking region in the family to present the seat on plan view.

0 Likes
Like
Report
Message 5 of 7

ennujozlagam
Mentor
Mentor
in reply to AnnaK246
‎03-21-2022 08:53 PM

i tried still the same. the best option is @ToanDN suggestion. or lessen the length of your sweep blend legs chairs. thanks





Remember : without the difficult times in your LIFE, you wouldn't be who you are today. Be grateful for the good and the bad. ANGER doesn't solve anything. It builds nothing, but it can destroy everything...
Please mark this response as "Accept as Solution" if it answers your question. Kudos gladly accepted.
0 Likes
Like
Report
Message 6 of 7

AnnaK246
Contributor
Contributor
in reply to ennujozlagam
‎03-21-2022 09:10 PM

Thank you. Do you think this is a graphics bug?

0 Likes
Like
Report
Message 7 of 7

ennujozlagam
Mentor
Mentor
in reply to AnnaK246
‎03-21-2022 09:21 PM

nope is not a bug, i tried in my pc and same result. or maybe model the sitting part into a extrusion or sweep so need the extrusion void, model it in different approach ? thanks





Remember : without the difficult times in your LIFE, you wouldn't be who you are today. Be grateful for the good and the bad. ANGER doesn't solve anything. It builds nothing, but it can destroy everything...
Please mark this response as "Accept as Solution" if it answers your question. Kudos gladly accepted.
0 Likes
Like
Report
Report a website issue