Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
There used to be a way to modify the stair stringer channels to extend at the top and bottom as shown below. Is this still possible? I can't do it in Revit anymore.
That was only available for stair by sketch in older version of Revit. Now, you have to create a solid mass to cut them, or create custom tread/riser profile and set them back, or model the support as structural frame and cut them.
