Spot elevation and Roof Problem

[mcankusmez]

Hi.Firstly, ı cannot add my elevation head How can ı add and seen my spot elevation head ? .Secondly, I did a roof but when ı look roof on roof plan,it looks like the picture is it true ?

[Anonymous]

Just place new Spot elevations for the new floors.

You don't actually say what the problem with your roof is.  We don't know what its supposed to look like.  Perhaps the view is set to Wireframe, if that is what you are referring to.

[barthbradley]

.   

[mcankusmez]

my roof lookslike picture with 3d

[mcankusmez]

ı cannot see your solution 

[Anonymous]

It looks as if your view range isn't high enough to see the plan.  Set it to be higher.

[mcankusmez]

How can ı do it.Shall you do it and record video for me when ı upload my project ?

[barthbradley]

---

@mcankusmez wrote:

How can ı add and seen my spot elevation head ?

---

Do you understand that Annotations (e.g. Spot Elevations, Tags, Text) are VIEW-SPECIFIC ELEMENTS? 

View-specific elements display only in the views in which they are placed.

---

@mcankusmez wrote:

Secondly, I did a roof but when ı look roof on roof plan,it looks like the picture is it true ?

---

 

[mcankusmez]

I didnt understand just when ı upload my elevation head ı want to see with edit type like the picture.You can see my evelation (Turkish evelation head) is not seen this panel 

[mcankusmez]

Do I need to upgrade the value in the view range ? If your answer is yes.How can ı change ?

[Anonymous]

It's not clear what you're asking.  Your roof doesn't display properly because the view range is not high enough to see the whole roof.  Barthbradley shows in his post how to adjust the View range so that you can see the whole roof.  Look for View Range in the View properties.

Are you asking about copying your spot elevations - as mentioned, these are view specific.  Create new ones to show on different elements.

Or are you asking about the Spot Elevation head?  If so what are you asking?  Note that the Elevation Head has nothing to do with the View Range.

[ennujozlagam · Accepted solution]

you wrote:

Do I need to upgrade the value in the view range ? If your answer is yes.How can ı change ?

please see screencast. thanks

https://autode.sk/2Wg5LOt

[mcankusmez]

thank you thank you so much. I solved the problem with the issues but ı have a question how can ı draw flue or flues gap ?

[ennujozlagam · Accepted solution]

you can try to use model in-place extrusion or sweep. thanks