schedules duct vs level

[Anonymous]

Hi,

when i do a duct's schedule, i manage to get in lengh, width, height... without any problem.

But, no way to get in the level parameter (the one which the duct was created).

The "reference level" is a duct parameter inside the "constraints" group.

Why, in the available fields of the duct schedule, i can't find this parameter ?

thanks for your answers.

Franck. 

[Anonymous]

Hi,

when i do a duct's schedule, i manage to get in lengh, width, height... without any problem.

But, no way to get in the level parameter (the one which the duct was created).

The "reference level" is a duct parameter inside the "constraints" group.

Why, in the available fields of the duct schedule, i can't find this parameter ?

thanks for your answers.

Franck. 

[Ilic.Andrej]

Use "comments" parameter and write anything you want.

[Ilic.Andrej]

Use "comments" parameter and write anything you want.

[Anonymous]

ok but i will not write the level in the comments field for each duct !

i must have about one thousand duct in my project....

[Anonymous]

ok but i will not write the level in the comments field for each duct !

i must have about one thousand duct in my project....

[barthbradley]

---

@Anonymous wrote:

ok but i will not write the level in the comments field for each duct !

i must have about one thousand duct in my project....

---

But how many Levels do you have? It would be easy to isolate all the ducts in the project and then window select all of the ducts on a particular level and give them the same identifier simultaneously.   

[barthbradley]

---

@Anonymous wrote:

ok but i will not write the level in the comments field for each duct !

i must have about one thousand duct in my project....

---

But how many Levels do you have? It would be easy to isolate all the ducts in the project and then window select all of the ducts on a particular level and give them the same identifier simultaneously.