Rotate Conceptual Mass Face

[PhilvK]

In a Conceptual Mass, isn’t there a way to rotate the face shown by the green “X” below onto the position by the red lines? I  know I can drag it out with the arrows (not shown), but I need it be at a specific angle.

[PhilvK]

I figured this one out too. You go to the elevation view perpendicular to the face you want to rotate, select it, then rotate it. (Still learning things)

[Anonymous]

Isn't this rotating also the top face?

[Alfredo_Medina]

You could simply move that top edge out.

Something similar to what I replied to you in this other thread:

http://forums.autodesk.com/t5/revit-architecture/mass-help-with-basics/m-p/5550761#M89475

[PhilvK]

Alfredo - Yes, it is the same thing. I just wanted to know how to rotate that face out at a specific angle, not just by length by moving the edge. I think I understand it now. Also, thank you for reminding me of the earlier thread!

[PhilvK]

Lucian - Yes, you are correct. I was kind of hoping you could stretch the corner as you could in SketchUp and the top would stay level. Oh well....

[Anonymous · Accepted solution]

Hi PhilvK,

If you still want to give as input an angle you can add some parameter to control how much the top edge will be shifted.

Please check the video below.

https://screencast.autodesk.com/main/details/c1e8c19c-8140-4f9e-a6aa-c2995b30fc7b

Hope this helps!

Lucian

[PhilvK]

Perfect! Thank you very much!

[Anonymous]

You're welcome!