Ramps Phasing

[Anonymous]

I am using Revit Residental Template for the sheeting and shoring of a future building.

I have incorporated the solider beams, tiebacks, and grade. Attached is a screen shot.

The outstanding item is showing the different steps to excavate the dirt.

How do incoporate 3 different phases of the site? See attached.

Phase 1 is from grade to 10 feet below grade.

Phase 2 starts 10 feet below grade. Then at the end, the site will be at a slope from 30 feet below grade to 10 feet below.

Phase 3 starts as Phase 2. but the ramp is flipped to the other side of the site. This is to get the complete site 30 feet below grade.

Thank you!

[Anonymous]

When I submitted this, there was an error. So I resubmitted and now there is two post! Sorry for the confusion.

[RDAOU]

DUPLICTAED POST

Original post discussed on the following LINK ->>> http://forums.autodesk.com/t5/revit-architecture/ramps-phasing/td-p/6316486

Phasing is not same as construction sequencing...see reply to other post

[Anonymous]

My thoughts are to do each END sequence under a Phase. Unless there is a better way to do this.

Which post should I be looking at? I am not seeing it.