"Profile sketch is empty!"

[ecastillowario]

Hello when i try to set my doors i have an error, An error occurred in family "M_Door-Passage-Single-Flush" that cannot be automatically resolved.
Error Information:
"Profile sketch is empty!"

help!

[jay_colc]

The error defines the issue here and if you close an empty profile sketch this is the warning, have you edited the family at any point?

Try reloading in the original from the Autodesk Web source if not and see if you can repeat. 

Insert Tab > Load From Library > Load Autodesk Family

[ecastillowario]

yes i edited, and i also reloaded the family but im having same problem, is just in specifics spots of my architectural plans. and some other im able to do it. 

[ennujozlagam · Accepted solution]

try this door?

[ecastillowario]

it worked, Thank you!

[JHROPE]

other better option is to disable the "Masonry Frame" in the door properties

[s337677]

Heyo, had the same problem.

Apparently in my case, my wall was too thin (100mm) for the Door, thus the "Profile sketch is empty" error. Hope this helps someone!

[Sleepingfish_Kuo]

Yes, it cause by a zero length line in sketch.

[hande_cadirci]

omg thank you so much

[hande_cadirci]

thank you so much