Opening placement Options

[Anonymous]

I would like to know where could I please find the opening placement options that appeared in the picture.

Many thanks 

[planner_matlabi]

Hi

Please explain more about what you are doing?
and

Which Revit Version?

This is related to the old version

[Sahay_R]

Hi @Anonymous - look in the Architecture tab>>Opening group

(mine is greyed out because I am not in a view - if you are in a view all these options will be active)

However, I don't see the options from your screenshot. Hopefully, this does what you want it to.

[Anonymous]

I am trying to create a dormer in a mansard roof with double slope but apparently it is not possible to get it due to the two different planes that conform the roof.

Thanks

[cbcarch]

You could also use an in-place Void to Cut Geometry for the roof(s).

[planner_matlabi]

Watch Screen cast

[ToanDN]

I don't have any problem create a roof dormer over a mansard roof.  See attached Revit 2017 file.

[bimscape]

I'm guessing the difference is that you  (@ToanDN) created your roof by extrusion- so it's one roof- which the Dormer tool likes, and the OP created Mansard as 2 roofs- one on top of another (both by footprint)- lower one using a Cutoff Level- so the Dormer tool is grumbling about the two roofs?

[Viveka_CD]

Hi @Anonymous

If you find posts have solved your problem, please click on 'Accept as solution' to help others with similar questions.

Thanks!