- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
Hi,
I got the revit drawings for designers and these are all linked each other. Let's say structure.rvt, mep.rvt, arch.rvt.
I just created RCP file from 3D scanned.
And I inserted point cloud on to my MEP Project file(I adjusted point cloud location by moving and rotating) The location is not perfectly accurate, but based on this point cloud location, I'd like to adjust other discipline's revit project file. For example, I'd like to revise existing column locations based on where I located in Mep.rvt.
I know to revise structure.rvt file, I need to close mep.rvt first, and then open the structure.rvt. However, when I open the structure.rvt file, I need to re-insert point cloud and move and rotate the point clouds again. By doing so, the accuracy of location of point cloud is not same as I've done in mep.rvt file.
Is there any way I can locate the point cloud file into structure.rvt as I located in mep.rvt ??
Solved! Go to Solution.