Levels do not appear correctly in model

[Homecad2023]

Hi there

I am trying to put level notation at different floor levels that are dropped at different levels.  If I pick the top of the floor the level marker shows but the text does not.  On one of the dropped panels the level marker appears and it is noted correctly.  I cannot figure out why this works for one panel and not the other 2.  If you look at the image in 3D it sort of explains it better what I am trying to do.

Any suggestions would be great, I think it is a view range setting but I tried everything

Thanks

Tony

[ToanDN]

Not sure which ones not showing correctly?

[Homecad2023]

In 3D they look fine but if open the sample file, in the Top of Pour plan you will see my notes of which ones are not working.  I need them to appear correctly in plan view as well as 3D

[ToanDN]

Raise the view range and replace the spot elevations,

[Homecad2023]

thats great however I would like to have my cut plane cut through my walls so is it possible to have your cake and eat it too? 🙂

[ToanDN]

---

@Homecad2023 wrote:

thats great however I would like to have my cut plane cut through my walls so is it possible to have your cake and eat it too? 🙂

---

Yes you can.  Keep the view range cut plane as your have it, draw plan regions around the platform and change their cut plane independently.

[Homecad2023]

I did use view range at the front but I was hoping there was some other solution.

Thanks for your posts, your suggestions were great