Glass divided on corner

[LanggamanXavierMassed]

I have extruded a sloped glazing and the finished glass tend to separate on the corner. I think what causes this is it is allotting a space for a mullion? I need this to be continuous, system panel family and the overall curtain wall properties is shown 

[Redrunner92]

That is going to be an expensive piece of glass. Fabrication, shipping, and labor to install it will be quite costly if it's one single piece.

I don't believe a curtain wall panel will make that change in planes without a break in the glazing panes.

[LanggamanXavierMassed]

yes that is true but they only have to touch each other, not as 1 whole piece of glass

[barthbradley]

...if you need it to be continuous, use a basic roof of the same thickness and material as the sloped glazing.  

[bin · Accepted solution]

You can change the offset of the panel to 0 and adjust the mullion offset instead.

[LanggamanXavierMassed]

oh I understand now!  the panel is created parallel on the extrusion lines because it's being offset, but it does not automatically join and is only projected perpendicularly.  I put the offset to 0 and it's ok now 

[barthbradley]

---

@LanggamanXavierMassed wrote:

oh I understand now!  the panel is created parallel on the extrusion lines because it's being offset, but it does not automatically join and is only projected perpendicularly.  I put the offset to 0 and it's ok now 

---

Yes, that exactly what I was pointing out in my screenshot above.  I figured the picture was worth a thousand words. TAB-Select the individual Panels and use can adjust each Instances "Extrusion Start" and "Extrusion End" Properties.