Footing cleaning out

[Anonymous]

I have my wall footing set with an Eccentricity of 2 1/4". When I do this it doesn't allow my footing to clean out at the corners. Any ideas how to fix this?

[ToanDN]

Grip stretch the end of the footing out a bit then you can use Align tool to align them.

[Anonymous]

Thanks for the reply. I tried what you said but it will only clean up on side. My outside of footing line is set to be in line with the outside face of my wall.

[ToanDN]

Do the same steps for both sides.  See screencast in a few minutes.

https://knowledge.autodesk.com/community/screencast/77c15686-3b13-4029-a5f4-abaa958f0b88

Screencast will be displayed here after you click Post.

77c15686-3b13-4029-a5f4-abaa958f0b88

[Anonymous]

I did the same step for both sides and only one side clears out.

[Anonymous]

Make a 5 1/2" wall and have your footing (24" wide by 12" deep) set to 3 1/4 Eccentricity (so the outside of the footing matches the outside of your wall) I still can not get the footings to clean up.

[ToanDN · Accepted solution]

---

@Anonymous wrote:

Make a 5 1/2" wall and have your footing (24" wide by 12" deep) set to 3 1/4 Eccentricity (so the outside of the footing matches the outside of your wall) I still can not get the footings to clean up.

---

Disallow join to the walls and manually join geometry then you can align the footing to the face of the walls.