Floor following topography using Dynamo

[r_thinagar]

Can anyone please help me to solve this issue . When I used dynamo to floor following topography, some cases it works but in some cases it resulting this issue (Slab Shape Edit Failed).Please find the attached image.Thanks

[Mark.Ackerley]

Hey,

I'm not sure which package your rooforfloor.bypoints node is from, but there's a similar one in Clockwork "Floor.SlabShapeByPoints" which I have used successfully on very complex shapes...

In your case, I suspect that if you "PruneDuplicates" that might help, perhaps get rid of points closer than 50mm? 

Incidently, incase you weren't aware, Dynamo has a dedicated forum at https://forum.dynamobim.com/ where you might get more responses.

Hope that helps,

Mark