Filled Region not visible on Architecture Discipline

[SdinizF]

Hello,

I created a new family as Electrical Fixtures that contains a fixture and 2D drawings with a filled region.

When I set the discipline to Architecture, Coordination or Structural, the filled region only shows its borderlines, the fill becomes void.

It works with Mechanical, plumbing and electrical disciplines.

Can someone help me? I want to create an Electrical Fixture (with the Electrical Connector) with only 2D drawings.

The problem of using it with Electrical Discipline is that all non-electrical becomes "halftone" and I can't control it.

The result I want to achieve:

[barthbradley]

Post the family here.  

[SdinizF]

Here is the file. Thank you!

[barthbradley]

I can't replicate what you are describing. The only issue I see, is that the Fill isn't constrained properly.

[barthbradley]

Post the Project File (RVT).  

[SdinizF]

I created a new empty RVT file and had the same result as you, so, I searched in my file and the problem seems to be on visual style. It is working fine on "wireframe" but not in all others. I can't find what setting is causing this.

Sending a copy of the project attached. Look at the floor plan.

[SdinizF]

File

[ToanDN · Accepted solution]

You devices are at 0 so that the filled region is covered by the floor plate.  Set the devices above 0 elevation or hide the floor.

[barthbradley · Accepted solution]

The fixture is buried in the floor. Raise it up.  

[barthbradley]

Sh*t! That was waste of my time. 😉 

[SdinizF]

Thank you for all help!

I created a masking region and now is fine.