Hi there,
I am stuck with a small issue, yet I cannot seem to figure out what is wrong or what I need to do. I have tried everything I could think of, but still cannot get my "block" to work.
I created a Corner Base Filler family for casework, where two (2) cabinets are edge to edge in a corner of a room. So I have this corner filler that will be placed in the corner where the two (2) cabinets meet. The thing is I was able to get the one edge of the filler to work, so that I can control it and have it be any length. I cannot get the other edge to do the same thing. Any advice, input, or solutions is greatly appreciated!
I have the family attached, I am using Autodesk Revit 2017.
