Error with default rotation point with created family.

[Anonymous]

I created a cabinet family and I can't figure out why the default rotation point, when placed in project, is 3ft over from the center of the cabinet, were it should be. (See Picture below)

[barthbradley · Accepted solution]

Clean the family up. Sounds like some extraneous information (e.g. Ref. Lines.) are being recognized and included in the extents.  Keep in mind that Ref. Lines can be labeled "not a reference", "weak", "strong", etc. 

...and "origin" 

[Anonymous]

@barthbradley 

I don't know what could be causing this, because I have other similar cabinets without this problem. If you have the time to see the URL below, you'll see the cabinet. I think it's cleaned up pretty well, but obviously there's something going on.

https://tmisystems4-my.sharepoint.com

[Anonymous]

I found the issue. i had a small ref plane located far right of the geometry.

Thank you for the response and your time!