Door family

[Yara-architecture]

I create a door family with thickness wall 150 c.m  but i can't insert it in the project with a deferent thickness of the wall

[Sahay_R]

Was it created in the Door family template? Door families will adjust to the thickness of the walls.

[Yara-architecture]

yes, created in the Door family template

[Yara-architecture]

if i insert it in wall with thickness for example 300cm it doesn't insert

[Sahay_R · Accepted solution]

Remove the wall thickness from the door family. The only dimensions that you should control will be the door dimensions, not the wall.

[barthbradley]

it doesn't cut through the wall? Or, it doesn't recognize the host as a wall?  

[Yara-architecture]

yes, it doesn't cut through the wall

[barthbradley]

Sounds like the door family uses a void cut instead of an opening cut. It probably isn't constrained correctly. Verify this it aligned and locked to the wall edges in the family -- or replace it with an opening cut.

Do you want to post family? 

[Yara-architecture]

thanks  for the help.

[Yara-architecture]

no, i don't want to post it, i will try that locked it to the wall edges in the family. thanks  for the help.

[barthbradley · Accepted solution]

okie dokie. Just to be clear: when I said "void cut", I meant that a void extrusion might have been used in place of the typical opening cut. So I was thinking that the extrusion isn't deep enough to fully cut through the wall. If so, easily fixed as I described. 

Good luck

[Yara-architecture]

thanks a lot.