Hi Everyone,
Was wondering if anyone could help with an absolute pig of an entrance ramp which curves and slopes every which way. Hopefully you can see what I need to achieve from the image below.
Any ideas would be much appreciated!
How about just create a floor, trim the edge for the profile, then add point to the floor(Shape editing).
You don't by any change have a Toposurface in the Project? If so, you could separate (via Split Region) the Toposurface under the Parking Lot area, Export it to DWG and Insert back into an In-Place Massing Environment, close out and apply a Roof by Face to represent the paving.
Other than modifying elevation of points on a floor and roof by face on mass, you can also create a slopes floor with height of 3 points, or just use topography and subregion.
Can't find what you're looking for? Ask the community or share your knowledge.