cannot attach wall into top base

[Anonymous]

hi i have folded roof but i cannot attach all of my wall at the bottom of the roof.

any one can help ? thx a lot

here i attach my file

[RDAOU · Accepted solution]

@Anonymous 

The wall is not within the footprint of the roof...Either move the wall under the roof or slightly adjust the roof.

[Anonymous]

I have tried it works, but there is something wrong again .what happened ?

[RDAOU]

@Anonymous 

The attach detach was the wall being outside the footprint of the roof...This is something ELSE. You have a gap in between the roofs through which the wall is bleeding/not attaching. Zoom out, align and close the gap between the 2 roofs and that bleeding piece will be gone

[Anonymous]

sorry i have checked there is no gap, i try to align it but it cant

in the left side of the roof there is no problem just in the right side the wall cant attach perfectly

[RDAOU]

@Anonymous 

This is your model in the GIF above...and there is a gap! You need to tidy up your roof 

Anyhow...I hope that we are not solving all the problems in that model in one post 🙂

[Anonymous]

here i sent you the file

[Anonymous]

hi oke i make different post for solving that problem

[RDAOU]

It is fine! Just zoom in to the roof and have a closer look