Best way to angle cut top of parapet wall?

[skyeg321]

Curious if others might know the best way to do this. I want to show the tops of all the walls that you can see in the attached 3D view with the top angled similar to how its shown in the detail. 

[ToanDN]

Draw a sloped ref plane and attach top of the walls to it.

Or are you asking how to model the coping on the sloped parapet walls?

[barthbradley]

In-Place Void Sweep cutting TOW would be one way to do it. 

...or perhaps not a Void, but a Solid Geometry representing the sloped cap.  

...or build  the cap into the Wall Type.

[Yien_Chao · Accepted solution]

@skyeg321  we use a profile to cut the top and another profile for the extrusion,

[skyeg321]

I was just looking to make the cut then let the detail callout handle the cap but If I can model it in I just may do that! Thanks everyone.

[ToanDN]

I thought you want to cut the parapet walls follow the red line below?  No?

[skyeg321]

No I must've used that screenshot to communicate something else to a teammate. Sorry messed you up.