Baluster not meet top railing ??

[hn_aec_05]

Hi every one,

I've already made railing and set baluster meet top railing and it's looked fine in example preview. 

But when I put it in staircase, when I see in Section it doesn't meet top railing, and it look quite weird.

Can anyone help me with this problem ?

Please refer from this picture for more clear information.

Thanks in advanced !

[Martijn.Pater]

Could be that you have to edit the baluster type properties for the selected baluster family (and/or check constraints in the family itself). edit: height parameter that is, if there is one else you'll have to edit the baluster family. Maybe share the file, easier to troubleshoot.

[hn_aec_05]

Thanks for your very quick reply. Maybe this file is bigger than maximum attachment allowed so I can't upload to this.

So please download from this google drive link below.

You can refer this staircase at sheet "A,II,14 - SH02 - STAIRCASE 01 SECTION"

https://drive.google.com/file/d/1DI7BvE77yfS4-uuypUuvatiCPVUgR-mY/view?usp=sharing

Hope to receive your response soon.

[ToanDN]

1. Is that a top rail or a handrail?

2. Edit you baluster family and check these:
- Properties: Post box is NOT checked
- Geometry: the baluster itself should go past the sloped reference plane above; a void properly constrained to the plane and cutting the baluster to create the sloped top

3. Copy paste the railing to a new file and share it here.

[sangamesh.b]

Hi, My name is Sangamesh, Im also facing the same issue please someone help if you have the

solution...

[markjohnlouieco]

Just make sure that the Top Cut Angle is higher the your baluster height