Aligned Dimension in inclined wall

[Anonymous]

Hi,

I would like to know, how does make aligned dimension at inclined wall. I tried several times but I couldn't pick both end of wall. Kindly find my screen shot of said subject.

txs

[RDAOU]

Hi @Anonymous

• Select the wall >> Right click the end grip control >> select Disallow Join
• Start the Dim command >> tab the unjoined end to select first end
• then tab the intersection Point to select second Point at the other end
• After you place the Dimension >> go back to the first end and right click >> Allow join
• lastly, select the Dimension extent grip and move it to the intersection (inner or outer)

I will add a screencast once it is uploaded to the server

[Anonymous]

Kindly sent me screencast if possible. Because I try but still I didn't get the steps.i reach until disallow joint after that I cannot.

Txs

[RDAOU · Accepted solution]

Hi @Anonymous

Sorry for the delay ... see screencast

[ToanDN]

Edit: didn't realize @RDAOU already uploaded his screencast.

___

My dirty way of doing it.

[RDAOU]

@ToanDN

Even if u did  : o) where is the harm in a new trick even if it comes sometime later 

ToanDN wrote:
Edit: didn't realize @RDAOU already uploaded his screencast.
___

My dirty way of doing it.