absolute coordinate system

[jsworks]

How do I get into the absolute coordinate system?

jksjim

[dmitriy.dolgikh]

Hi @jksjim,

Could you please provide a bit more context for your question? What problem are you trying to solve?

Thanks!

[jsworks]

Hello Dimitriy,

There's been some communications errors with Autodesk Community messages going into my Junk Mail folder. I had to move all messages into my Inbox in order to read them. I noticed that you are answering for the Power Inspect Forum, so I'm not certain whether my inquiry would be covered by you. But in case you have an answer, I will provide you with more info.

I'm working with ACAD 2018, on exercises from a textbook. The exercise is to simply draw a square using the line command. However, the textbook wants this exercise to be done in the Absolute Coordinate System. The only instruction was to: start dwg>templates>acadISO-named plot styles.dwt. But there are other prerequisites that have to be setup 1st. So I'm hoping that someone will help me navigate into Absolute Coordinates. 

Regards,

jksjim

[dmitriy.dolgikh · Accepted solution]

Hello jksjim,

Indeed, your question has appeared in PowerInspect forum. I am sorry, but I cannot help with AutoCAD questions. 😞

I appreciate that Autodesk forums could be a maze. I think that the easiest way to get help would be to re-post your question with the details above in AutoCAD forum here.

I hope it helps!

Thank,

Dmitriy

[jsworks]

Hi Dimitriy,

I'm replying to an older post of yours because I seem to have lost your new post for Absolute Coordinate System.           I agree that there was too much info being posted and that I should start anew. However, I decided to suspend further search for a definitive solution to Absolute Coordinate System. Thanks for your patience regarding this issue. Also, thanks to Paul Li, & Kent1Cooper for their participation.

Best Regards,

jksjim

[jsworks]

Dimitriy for your suggestions & help were appreciated.

jksjim