STL settings compared with Fusion360

[Anonymous]

Hi all,

Hope someone can help I have 2 identical photo one from Inventor and one from Fusion360. I need to work on a STL file in Inventor but i can't see the geometry right.. it's much better in Fusion 360, are the some settings or colores I can change, so I get the same result in Inventor?

The optimal would be this. this is from MeshMixer

[Frederick_Law]

Change display to: shaded with edge.  It'll be slow.

[Anonymous]

hi @Frederick_Law,

It's already have this settings

[JDMather]

Have you run AutodeskMeshEnabler on the geometry and converted to solid or composite surface?

Once you have converted you should be able to apply any Appearance properties.

[Anonymous]

Hi @JDMather,

I have solved this:-)

This setting do all the job, I have tried all down under but not this one:-)

So another question, how good are Inventor to clean a mesh?

[Frederick_Law]

---

@Anonymous wrote:

So another question, how good are Inventor to clean a mesh?

---

Not too good.

I use 3D Scan software to make it a solid first before using it in Inventor.  At least I can use it to cut/intersect another solid.