I'd probably dimension it more like this.. I like to dimension to what can be measured by calipers,etc... easily.
Makes the inspectors job much easier.. You can add the missing dimensions based on your measurement setup..
I just think the overall 41.46 dim is better/easier to dimension too and the 42.2 angle is easier IMO than measuring from the smaller tip. But that really depends on your qc setup,etc...
-------------------------------------------------------------------------------------------
Inventor 2023 - Dell Precision 5570
Did you find this reply helpful ? If so please use the Accept Solution button below.
Maybe buy me a beer through Venmo @mcgyvr1269