Mix-matched units in Parameters using exponets

[Anonymous]

Can someone help with this equation please. I am having trouble with mix matched units.

( ( ( 0.5 ul ) ^ ( MD * PI ) ) ^ 0.5 ul + ( PIPEOD ) ^ 0.5 ul ) * d17

d17        is unitless

PIPEOD   is inches

MD         is inches

Thank you for your help.

[YannickEnrico · Accepted solution]

This should be usable:

isolate(Width;mm;ul)

Isolate(yourfunction;currentunit;expectedunit)

Edit:

Actually not sure if it works with an entire function, but then you can isolate the parameters separately

[SBix26 · Accepted solution]

Are you sure this equation is correct?  Written out in mathematical notation, it looks like this:

 

I can't make any sense of the units from this, so it's not too surprising that Inventor's math engine can't either.  What are you trying to calculate?

Sam B

Inventor Professional 2017.3.1
Vault Workgroup 2017.0.1
Windows 7 Enterprise 64-bit, SP1
Inventor Certified Professional

[Anonymous]

Thank you guys. Yes i wrote the equation wrong. It was late in the evening when was doing this. Thank you for answering and your input. I wrote it over after reading your post. 

((((MD*PI)^(2 ul))+(PIPEOD^(2 ul)))^(0.5 ul))*TIGHTLOOPS

MD is in inches

pipeod is in inches

tightloops is unitless