Loft Creation error

[veenal.datt]

I am trying to loft 4 geometries as attached with 3d lines intersecting all of them.

Cannot seem to execute this. Any help would be appreciated. Thanks

[kacper.suchomski]

Hi

The guide cannot be construction.
You need to add a bottom guide.
This can be done in segments.

[veenal.datt]

Ok I think I tried what you asked for. As a result below which again had issues

[kacper.suchomski · Accepted solution]

I also wrote to do it one by one in segments.

[WHolzwarth · Accepted solution]

As already mentioned by Kacper, lofting from section to section is best.

Here's a solution with some cleanups in loft transition lines (2024 IPT). I can do it in 2021, if needed.

[veenal.datt]

Thank you for help. Sorry ingored that bit. It works well