K-Factor Not changing Inside radius

[henryjoseph9804]

Hi All,

I currently have a situation where I need to draw up some stuff from an old drawing. The material thickness for one of the plates is 5mm but with an internal radius of 3mm. I tried adjusting the K-Factor to give me an internal radius of 3mm but with no luck.

Can anyone perhaps provide me with some guidance?

Thanks

[Lars_Greft · Accepted solution]

Hello, if you open "Sheet Metal Defaults", then click on the pencil icon and go to the tab "Bend", there you can change the Bend Radius.

[henryjoseph9804]

Thank you so much!