Inventor: Constrain tool remembers the last choice

[rafael.barata]

Hello all,

I have Inventor 2019.2 and since the last update, when I start the constrain tool, it chooses my last choice between mate and flush instead of start allways with mate constrain. I know its just a preciosity but I am to much used to this to change it. I'm over-doing clics and undoing constrains sucessively because of this.

Is there any way that I can costumize this so it start allways with mate?

Thank you for your comprehension.

Regards,

Rafael Barata

sergio.bertino has edited your subject line (Constrain tool) for clarity.

[JDMather · Accepted solution]

I suspect that you will quickly get used to the new behavior of Inventor “remembering” the last use.

As far as I know - there is not yet an Application Option to custmize this new behavior.

[Sergio.Bertino]

Hello @rafael.barata,

I see that you are visiting as a new member to the Inventor Forum.
Welcome to the Autodesk Community!

As @JDMather said, at the moment there is no option to bring back the legacy behavior.

There is another discussion on this topic here.