How to dimension to a Insert Sketch Symbol? I know it is very easy in AutoCAD, but inventor Dimension does not see my sketches. I am adding power and speaker locations to a room. I just need approximate locations.
It would be a hardship to have to model and insert speakers in the drawing. I did that with track lighting bars.
I need to do the same with the Cat6, power, dimmers
You can't..
You could place a work point at those locations though I believe..
another workaround here..
@Anonymous I notified the moderators to remove your other duplicate post..
This post should stay and be used for replies if needed..
Hi ck1way-work,
I've had to do this in the past for some layout type work, and have done this:
Note: In the video I used a layer to hide the geometry, but this might hide your sketch symbol geometry too, depending on your layer set up. So you might need to move the sketch geometry to a different layer and turn that layer off. Or use the Sketch Only button when editing the sketch to make the lines only visible when editing the sketch (see image below).
I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com
Can't find what you're looking for? Ask the community or share your knowledge.