How to close this gap

[Julie-Tang]

Hi all, I was wondering how you would best close  this gap area highlighted here in the screen shot

I tried to add a 45 deg flange on the vertical edge and then a corner seam  but it wasn't turning out how i hoped.

or would it be better for me to draw a seperate piece then assemble it?

Any help is appreciated, thank you

[kacper.suchomski]

Hi

Can you sketch on the screen what exactly you want to achieve?

[Julie-Tang]

something like this screenshot, without the top corner poking out

ideally would like the bottom corners to meet at the same point

[Julie-Tang]

file

[Julie-Tang]

ipt file

[BDCollett]

Something like this?

I created two work axes, then a plane to establish the location of the new face. Then Corner Seam to finish.

[Julie-Tang]

Would you mind sharing the file, so I can see the steps to how you did it. sorry I’m not the smartest from just reading

[BDCollett]

I created this in 2025, if you have the latest patch for 2024 you should be able to open this.