Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Is there a way in the cable & harness to modify the adjusted length? As the round ups sometimes put the cable too high or too low. The length of the wire is shown as 2.71", but we want it to be 3.5" and when I do the different round ups I have gotten 3.25" or 3.75" but not 3.5". We want it slightly longer than the actual length due to the fact that it is attached to an NPT and it might not land in the exact spot the model shows when threaded in.
No not really outside of changing the wires routing..
There really isn't a valid way to fix/define the length of them.
You can change the wire routing, adjust the global slack %, change the roundup and you could change the authored pins strip length value to add more but thats it.
